Maximum how many hop count has RIP?
20
15
25
150
SHOW ANSWERUp to how many equal/unequal costs RIP supports load balancing?
Five, unequal-cost
Eight, unequal-cost
Two, equal-cost
Six, equal-cost
SHOW ANSWERRegarding RIPv2, which of the following is true?
It uses triggered updates.
It uses updates.
It is classified.
It doesn’t support route summarization.
SHOW ANSWERWhat is the main reason of using RIP?
Easy to manage
For small network
Support all features
All of the above
SHOW ANSWERRIP is a ____________ protocol.
Distance Vector Protocol
Path Vector Protocol
Link State
Routed protocol
SHOW ANSWERRIP decides the best path (routing metric) base on _______.
bandwidth
Delay
Hop Count
Link Speed
SHOW ANSWERThe Maximum Hop count for RIP is _____.
15
16
255
99
SHOW ANSWERRIP defines two types of messages:
Hello message
Request Message
LSA
Response Message
SHOW ANSWERYou can enable RIP on Cisco router by following command:
R(config)#router rip
R(config-if)#router rip
R#router rip
R4(config)#router rip version 2
SHOW ANSWERThere are different timers that are used in RIP, choose the three correct from following:
Hello Timer
Flush Timer
Invalid Timer
Update Timer
SHOW ANSWERRIP send the routing updates to adjacent routers after every _______ seconds.
10
20
30
5
RIP version 2 has the following new features:
VLSM/subnetting
Authenications
area base division
stub area
SHOW ANSWERRIPv2 send the entire routing table to all connected routers at the multicast address _______.
224.0.0.10
225.0.0.9
225.255.255.255
224.0.0.9
SHOW ANSWER